Doepfer A-100LMB is a low-cost case for Eurorack synthesizer modules.
It is designed as a base for the Doepfer A-100LMS9V Case and has 2X3 height units, which are angled towards each other. Just like the Doepfer A-100LMS9V, it has a usable width of 168 HP and is supplied with two A-100PSU3 power supplies and four busboards.
Dimensions and weight:
outside dimensions: ~ 87 (length) x 19 (height) x 38 (depth) cm
weight of the case (incl. bus boards, power supplies, without modules): ~ ? kg
available 19" width and height: 2 x 3U x 168 HP
Quantity of bus boards: 4
Maximum Output Current:
two built-in A-100PSU3 : +12V/4000 mA, -12V/2400mA, +5V/8000mA
Usable depth for modules:
approx. 65 mm in the lower front row
approx. 90 mm in the upper angled row
(measured from inner side of the front panel until end of the pc board of the module)
Position of the mains inlet: center of the rear panel
All bus boards are located in the rear area (even those for the modules that are mounted in the front row). This was necessary to take advantage of the full height of the front area for installation of modules. The max. depth for modules in the front row is ~ 65 mm.